SWITCH 24B GB SMART POE 1GB 1FO DS-3E1526P-EI/M HIKVISION

Descripción

Conmutador POE inteligente Gigabit de 24 puertos
24 puertos Gigabit PoE RJ45, 1 puerto Gigabit RJ45, 1 puerto de fibra óptica Gigabit
Presupuesto total de energía PoE 230 W
Gestión unificada de la nube para sistemas de seguridad
Topología de red a su alcance
Solución de problemas remota
Gestión de topología visualizada
Transmisión PoE de largo alcance de hasta 300 m
Protección contra sobretensiones de 6 kV

Ficha técnica

10621 FICHA

Inicio rápido

10621 INICIO

Manual técnico

10621 MANUAL

Especificaciones

• General
• CarcasaMetal material
• Peso Neto2.96 kg (6.52 lb)
• Peso Bruto3.2 kg (7.05 lb)
• Dimensiones (W X H X D)440.0 mm × 220.8 mm × 44.0 mm (17.32» × 8.69» × 1.73»)
• Temperatura De Funcionamiento0 °C to 45 °C (0 °F to 113 °F)
• Temperatura De Almacenamiento-40 °C to 85 °C (-40 °F to 185 °F)
• Condiciones De Humedad5% to 95% (no condensation)
• Humedad Relativa5% to 95% (no condensation)
• Fuente De Alimentación100~240 VAC, 50/60 Hz, Max. 4 A
• Modo De InstalaciónRack (equipped with mounting ears)
• Max. El Consumo De Energía250 W
• Consumo De Energía En Inactivo30 W
• Surge Protection6 KV

• Parámetros De Red
• Puertos24 × Gigabit PoE port,1 × Gigabit RJ45 port,1 × Gigabit fiber optical port
• Tabla De Direcciones MAC8 K
• Capacidad De Conmutación56 Gbps
• Tasa De Reenvío De Paquetes41.66 Mpps
• Caché Interna4.1 Mbits

• Fuente De Alimentación PoE
• PoE StandardIEEE 802.3af,IEEE 802.3at
• Pin De Alimentación PoE8-pin power: 1/2(-), 3/6(+), 4/5(+), 7/8(-)
• Puerto PoEPoE: Ports 1 to 24
• Max. Puerto De Alimentación30 W
• PoE Power Budget230 W

• Función De Software
• Largo Alcance

  Ports 1 to 24: up to 300 m.

  Long range performance may vary depend on camera model or cable condition.

• VIP Port/
• Port Isolation

  Ports 1 to 24: port isolation mode to improve network security.

  Ports in an isolation group cannot communicate with each other, but they can communicate with ports outside the isolation group.

• PoE WatchdogPorts 1  to 24: auto detect and restart the cameras that do not respond.
• Link Aggregation

  Link aggregation is used to aggregate multiple physical ports to form a logical port for load balancing, bandwidth expansion, and port protection.

  Support static link aggregation.

  Support 8 aggregation groups.

• QoS/
• Loop Prevention/
• VLAN/
• HPP

  Support one-click activation and remote management via Hik-Partner Pro. Functions supported:

  1. Display the port rate.

  2. Display the port bandwidth utilization rate.

  3. Display the PoE power usage.

  4. Display topology information.

  5. Display the alarm status.

  6. Restart ports and devices.

  7. Enable port long-rage mode.

  8. Remotely upgrade the device.

• System Maintenance

  Support device management via web.

  Support DHCP Client. Enabled by default for dynamic assignment of management IP addresses.

  Support Super IP, which is a fixed IP address (10.180.190.200) for direct access.

  Support management via Hik-Central Pro.

  Support remote management via Hik-Partner Pro.

  Support cable detection. Abnormal open circuits and short circuits as well as network cable length can be detected.

  Supports 802.1ab LLDP for peer device discovery.

  Support SNMP v1/v2c for third-party management platform access.

  Support port mirroring for fault locating.

• Port Rate-Limiting/
• Storm Control

  Storm control is used to prevent switch ports from being blocked by broadcast or multicast storms in the LAN, which may affect network communication.

  Supports port rate limiting based on broadcast, multicast, and unknown unicast packets.

• DHCP Snooping

  DHCP Snooping can prevent unauthorized connections to DHCP servers from disrupting the network and affecting normal network communication, and only allow DHCP packets from trusted ports to pass through

  Off by default.

• ACL/
• IGMP Snooping/
• IPSG/

• Certificaciones
• EMC

  FCC (47 CFR Part 15, Subpart B);

  CE-EMC (EN 55032: 2015, EN IEC 61000-3-2: 2019, EN 61000-3-3: 2013+A1: 2019, EN 50130-4: 2011 +A1: 2014, EN 55035: 2017);

  IC (ICES-003: Issue 6);

  RCM (ASNZS CISPR 32: 2015)

• Seguridad

  UL (UL 60950-1);

  CB (IEC 60950-1:2005, AMD1:2009, AMD2:2013, IEC 62368-1: 2014 (Second Edition);

  CE-LVD (EN 60950-1: 2006 + A11: 2009 +A1: 2010+A12: 2011+A2: 2013, EN 62368-1: 2014+A11: 2017)

• Química

  CE-RoHS (201165EU);

  WEEE (201219EU);

  Reach (Regulation (EC) No.19072006)